Resin buckle production process

The resin button is a big category in the buttons. It has been well received by the public. Do you know what his production process is?

China Button Industry Network sums up the following six points for everyone:

(a), raw materials:

Unsaturated polyester is a raw material extracted from petroleum and is a transparent, viscous liquid. Resins with catalysts and hardeners can be added with different colorants, or other raw materials, such as wax, salt, sawdust, straw, etc., with different amounts of raw materials, at different concentrations, different temperatures, different rotation speeds and special Under the cooperation of accessories, it will produce ever-changing patterns. It is also an important material that can be used to imitate natural regenerated buttons such as imitation pearl shells, horns, fruits, wood grain, stones, and marble.

(b), sheet:

The fully mixed resin is poured into the rotating bucket, commonly known as the rewind bucket or large caliber, and can be poured as many layers as required. After approximately 30 minutes, the resin in the bucket can be cut into a plate shape due to the soft reaction of the resin. , and then placed on the embryonic machine, the new embryo out. A plate rushes out of 24L of neo-E.

(c) Sticks:

The completely mixed glue is poured into a waxed aluminum tube through a special oscillator. After the glue is pulled into a soft gel, the glue stick in the aluminum tube is pulled and sliced. The slicing knife can cut 1300 18L embryos per minute. . Each stick can be cut into 24L embryos.

(D), stick embryo:

All flake embryos or stick embryos are soft and must be placed in hot water at 80 degrees for 10 hours to speed up the chemical reaction. The embryos become hard embryos after complete reaction.

(5) New money:

Automatic car button machine can pass over the car surface, the bottom of the car and punch holes once, even if the engraving and engraving can be completed in one go. Ordinary four holes with a side and bottom New Zealand, can be carved out of 100 per minute, the same as the embryo and stick embryo.

(6) Polishing:

As the surface of the car and the bottom of the vehicle leave marks, it is necessary to put it into a water mill barrel. The slow-rotating water mill bucket is mainly filled with water and lime powder. This process takes ten hours. After the water is rubbed, the New Zealand has a dull mist effect. If the lighting effect is to be brightened, the bamboo core and the wax are mainly put in the brightening bucket. This process takes 20 hours; or a small stone and stone powder is used in the water polishing machine. To achieve the above effect, this process takes 15 hours.

Want to learn more about buttons: accessible

For more details, please pay attention to WeChat public number: